How to Change a Tire of a Lowered Car [10 Easy Steps]

Changing a tire on any car can be a frustrating experience, but if you have a lowered car, it can be even more challenging. However, with the right tools, techniques, and a bit of patience, you can change a tire on a lowered car without damaging your vehicle or yourself.

In this article, we will walk you through the steps involved in changing a tire on a lowered car.

Step 1: Find a Safe Location

Before you start changing a tire, make sure you find a safe and level location to do so. Pull your car off the road and onto a flat surface, like a parking lot or garage, and turn on your hazard lights to ensure visibility. Avoid changing a tire on a slope or incline, as it can be dangerous and make the process more challenging.

Step 2: Prepare Your Tools

To change a tire on a lowered car, you’ll need some specialized tools. These include a jack that is specifically designed for lowered cars, a lug wrench, and a spare tire. Check your vehicle’s manual to ensure that you have the right type of jack for your car. You can also find floor jacks for low profile cars in this article.

Step 3: Loosen the Lug Nuts

Before you lift the car off the ground, loosen the lug nuts on the tire you want to change. Use a lug wrench to turn the nuts counterclockwise until they are loose. You don’t need to remove them at this stage; just make sure they are loose enough to remove by hand later.

Also Check: Best Cordless Impact Wrenches for Changing Tires

Step 4: Lift the Car

Place the jack under the vehicle’s jacking point and lift the car off the ground. Be careful not to damage the underside of your car when lifting it. Once the car is off the ground, place jack stands underneath the car for extra safety.

Step 5: Remove the Lug Nuts

Once the car is securely lifted, remove the lug nuts from the tire you want to change. Use your fingers to turn the nuts counterclockwise until you can remove them. Be sure to keep the lug nuts in a safe place, as you will need them later.

Step 6: Remove the Flat Tire

Gently remove the flat tire from the car and set it aside. Be careful not to damage the rim or the hub of the wheel. You may need to wiggle the tire back and forth a bit to loosen it from the hub.

Step 7: Install the Spare Tire

Place the spare tire onto the hub of the wheel and line up the holes with the studs. Push the tire onto the hub until it is flush with the rotor. Tighten the lug nuts by hand until they are snug.

Step 8: Lower the Car

Using the jack, lower the car until it is back on the ground. Remove the jack stands and the jack from underneath the vehicle.

Must Check: Best Tires For Rock Crawling

Step 9: Tighten the Lug Nuts

Using a lug wrench, tighten the lug nuts in a star pattern until they are snug. Be sure not to over-tighten the nuts, as this can damage the wheel and make it difficult to remove the nuts the next time you need to change a tire.

Step 10: Check the Tire Pressure

Check the pressure of the spare tire using a tire pressure gauge. If the pressure is too low, add air until it reaches the recommended level.

Last Words

In conclusion, changing a tire on a lowered car can be a challenging task, but with the right tools and techniques, you can do it safely and efficiently. Remember to always work on a level surface, use a jack that is designed for lowered cars, and take your time when removing and installing the tire. By following these steps, you can get back on the road in no time.

Leave a Reply

Your email address will not be published. Required fields are marked *